MINOLTA-QMS Magicolor 2200 DP Guía de instalación descargar pdf (Pagina 44)

Installing Printer Drivers and Software42

Installing Printer Drivers and Software

Windows Using TCP/IP

TCP/IP Interface Configuration

Detailed instructions for configuring TCP/IP can be found in the

CrownBook

If you use DHCP to configure TCP/IP, you must enable DHCP/WINS in

Administration/Communications/Resident NIC/CrownNet/TCP/IP printer

configuration menu.

You can configure your print system by several different methods. This section briefly

describes the configuration procedure for the printer interface. You can make these

configuration changes through any of the following means:

„

Printer control panel

„

CrownAdmin 3 for Windows

„

Remote Console through a telnet session

If necessary, in the Administration/Communications/Resident NIC/CrownNet/

TCPIP/Internet Address menu, enter the printer’s Internet address.

The factory default Internet address is 161.033.128.024.

If necessary, in the Administration/Communications/Resident NIC/CrownNet/

TCPIP/Default Router menu, enter the Internet address of the default router.

The factory default router address is 000.000.000.000. This setting provides

automatic sensing of gateways. If you identify a subnet mask, automatic sensing

is disabled.

If necessary, in the Administration/Communications/Resident NIC/CrownNet/

TCPIP/Subnet Mask menu, enter the printer’s subnet mask.

The default subnet mask is 000.000.000.000.

TCP/IP Network Configuration

Log on the system as administrator.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 69 70

Sin comentarios

MINOLTA-QMS Magicolor 2200 DP Guía de instalación Pagina 44